Hydout

Using your

Hydout

Register your product

How to use

  1. USB-C cable plugged into the base of the Hydout
    1

    Charge

    • Plug any USB-C cable into the port on the base.
    • Pass-through charging: you can use it while it charges.
    • The display shows battery level while charging.
    • Give it a full charge before first use.

    USB-C cable not included.

  2. Magnetic mouthpiece cover removed, 510 cartridge ready to thread in
    2

    Load

    • Pull off the magnetic mouthpiece cover.
    • Screw in your 510 cartridge — snug, not cranked.
    • Snap the cover back on.

    Fits most 510-thread cartridges up to 2g. Cartridge sold separately.

  3. Single control button on the side of the Hydout
    3

    Activate

    5×
    Turn on Five quick presses
    3×
    Adjust voltage Cycles 2.4V → 2.8V → 3.2V → 3.6V → 3.8V
    2×
    10-second preheat Warms oil at 1.8V
    hold
    Activate + draw Hold the button or just inhale
    5×
    Turn off Auto shut-off after 10 min

    Lower voltage = more flavor. Higher = bigger clouds.

  4. Cotton swab cleaning the cartridge connection point
    4
    Cotton swab cleaning inside the mouthpiece cover

    Clean

    • Turn it off and remove the cartridge first.
    • Use a cotton swab + isopropyl alcohol (ISO).
    • Wipe the inside of the mouthpiece cover.
    • Wipe the cartridge connection point.
    • Let dry fully before reloading.

    Never soak the battery in alcohol or any liquid.


Videos


Upgrades

The Hydout in retro see-through colors.


Specs

View Product Details
Battery400 mAh
ChargingUSB-C
Heat settings5 · 2.4V / 2.8V / 3.2V / 3.6V / 3.8V
Preheat1.8V · 10 seconds
Auto shut-off10 minutes
Compatibility510-thread carts up to 2g
DisplayLED · voltage and battery level
Dimensions90 × 37.5 × 18.5 mm
Weight50 g
SKUGHO-001-AOZZ
UPC811736029254
Warranty90-Day Limited Warranty

Help

Common questions
Nothing happens when I press the button

The device auto-sleeps after 10 minutes. Press five times to wake it. If the display still doesn't light up, charge it and try again.

My cart isn't producing vapor

Make sure the cartridge is threaded in snugly — not over-tightened. Try a double-press for a 10-second preheat to loosen thick oil, then draw again — hold the button or just inhale.

Which heat setting should I use?

Start low. Lower voltages give more flavor and make a cart last longer; higher voltages give bigger, warmer clouds. Press three times to cycle through the five settings.

Will my cartridge fit?

The Hydout takes standard 510-thread cartridges up to 2g. Very wide or extra-tall carts may keep the magnetic cover from seating flush.

How do I know when it's fully charged?

The LED display shows the battery level. Leave it on the cable until it reads full.

What does the warranty cover?

The Hydout comes with a 90-Day Limited Warranty. Register your device and read the full terms on gpen.com, or contact support with your order details.

Still stuck?